I purchased this from lowes and it had the 1 year warranty.
Maytag bravos xl steam washer not turning on.
Maytag probably has the.
Repeat to turn them on.
Have a maytag bravo xl washer.
When i push the power button the machine does not turn on.
Do not use an extension cord.
Washer maytag bravos xl mvwb750yw use and care manual bravos xl top loading high efficiency low water washer 44 pages washer maytag mvwb450wq bravos 5 0 cu.
My maytag bravos xl dryer will no turn on.
Plug power cord into a grounded 3 prong outlet.
Appliance technician for 31 years.
For some models touch and hold the steam clean option for 3 seconds to turn off the tones.
I read more.
The dryer and light inside worked fine yesterday.
If so reset the circuit breaker or ground fault circuit interrupter.
Check to see if a household circuit breaker or ground fault circuit interrupter gfci outlet has tripped.
If the washer starts and seems to progress through the cycle well but doesn t move to the spin cycle the problem may be with the locking lid switch.
If it is turned on check your fuse box and correct any switch as necessary.
Owner rick s appliance repair.
See your owner s manual for more information about the tones for your specific model.
I believe the door switch went out that first year.
Maytag bravos washer will not continue to the next cycle after the wash cycle.
Check for 5 vdc at the j18 connector.
The light inside the dryer is not on either.
The done light has not have a maytag bravo xl washer.
It was not a happy birthday.
Iec capacity washer use and care manual.
The done light has not turned on the last couple of loads.
It was having it s 5th repair.
If the washer is on a fuse box check to see if a fuse has blown and replace it if necessary.
Piece of junk if there ever was one.
Check for 120 vac at the j12 connector on the board.
Unplug the machine and disconnect and reconnect the connector.
Below is an example of an end of cycle signal on some models.
As you have no power lights and the washer will not turn on please check that you have the machine turned on at the power point.